Sony MHC-5500 - Page 69

-
SONY.
SERVICE MANUAL
CDP-H500
AEP
UK
Model
Model
CORRECTION-1
Correct your service manual as shown below.
-- : indicates corrected portion.
Page
4
5
5
E-F Balance Check
Procedure :
INCORRECT
1. Connect test point TP (ADJ) and TP (TES) to
ground with lead wire.
Focus/Tracking Gain Adjustment
4. Adjustment RVlOl on BD board so that the
waveform is as shown in the figure below. (focus
gain
adjustment)
6. Adjusted MV102 on BD board so that the
waveform is as shown the figure below. ( tracking
gain
adjustment)
CORRECT
E-F Balance Check
Procedure: ~
1. Connect test point TP (ADJ) to ground and TP
(TES) to TP (VC) with lead wire.
~
Focus/Tracking Gain Adjustment
~
4. Adjust RV102 on BD board so that the waveform is
as shown in the figure below. (focus gain adjustment)
~
6. Adjust RV101 on BD board so that the waveform is
as shown !!! the figure below. (tracking gain
adjustment) ~
Adjustment Location
[BD board]
9-955-660-92
Sony Corporation
Audio Group
English
9110460-1
Printed in Japan
© 1991.9
Published by Customer Relations and Service Group
www.audiodna.sk