464
a) Output signal without format conversion
b) Not selectable on the XKS-C9121
c) “3840×2160P (Level A, 2SI)” on the XKS-C9121
1
In the Engineering Setup >Switcher >Output menu
(7333), press [Output FC].
The Output FC menu (7333.20) appears.
2
Press [FC Format].
The FC Format menu (7333.21) appears.
The status area shows the output list on the left and the
supported conversion signal format list on the right.
3
In the list on the left, select the target output to set.
Select an output from among the output grouping to
set.
When the switcher signal format is 3840×2160P, only
the output with the lowest number in the output
grouping can be selected.
4
In the list on the right, select the signal format.
5
Press [Set].
To clear the signal format setting
Press [Clear].
6
Press [Execute].
Setting the format converter conversion
method
You can set the format converter conversion method for
each output.
For details about the conversion method items and the
target conversion formats, see “Setting the format
converter conversion method” (page 462).
1
In the Engineering Setup >Switcher >Output >Output
FC menu (7333.20), press [FC Adjust].
The FC Adjust menu (7333.22) appears.
2
Display the target output to set in the status area.
Press [Prev] or [Next] to switch the display in the
status area.
Pressing [Prev] displays the previous four outputs, and
pressing [Next] displays the next four outputs.
3
In the status area, select an output.
4
Set the conversion method.
The operation is similar to setting an internal format
converter.
For details, see “Setting the format converter
conversion method” (page 448).
Setting the P/I Converter
The P/I converter converts a 1080P format signal to 1080i
for output. The P/I converter can be set for each group of
four outputs.
• On the XVS-9000, the P/I converter is not available. The
format conversion of output signals by output format
converters can be configured (see page 463).
• This setting is available only when the switcher signal
format is 1080P.
• Enabling the P/I converter will disable through mode.
• Format converter output connectors, spare connectors,
multi viewer output connectors, and M/E dedicated
output connectors cannot be set.
• On the XVS-7000, format converter outputs 9 to 12
cannot be used when the P/I converters for output
connectors 9 to 12 are enabled. And format converter
outputs 13 to 16 cannot be used when the P/I converters
for output connectors 13 to 16 are enabled.
• When using a network connector board (XKS-T8165/
XKS-Q8166/XKS-C8166), the board must be reset after
changing the P/I converter setting.
For details about resetting a board, see “Initializing
Network Interface Settings” (page 389).
1
In the Engineering Setup >Switcher >Output menu
(7333), press [Output P/I Converter].
The Output P/I Converter menu (7333.7) appears.
2
Select the target output to set.
Select one of the four target outputs to set.
3
In the <Output P/I Converter> group, press [1080i].
To disable the P/I converter, select [1080P].
4
Press [Execute].
Configuring Multi Viewer
The multi viewer is a function that splits the screen for
display of multiple images at the same time.
720P • 1080i
b)
•720P
a)
Note
Switcher signal
format
Output signal format
Notes
To Next Page
Loading...
