Basic Operations
Basic Operations
5
EN
• See page 4 for hookup
information.
• You can use either deck for
playback.
To play back Set to
One side only A
Both sides continuously* a
Both decks in succession* RELAY
4
Press ·.
The deck starts playing. Adjust the volume on the amplifier.
1
Turn on the amplifier and select the tape deck position.
2
Press POWER, and then press §
and insert a cassette.
3
Set DIRECTION.
To
Press
Stop playing p
Start playback from the reverse side ª
Pause (deck B only) PAUSE P. Press the button again to
resume play.
Fast-forward or rewind ) or 0 when the deck is stopped
Take out the cassette § after stopping playing
Playing a Tape
* The deck automatically stops after playing back five times.
Basic Operations
* Dolby noise reduction
manufactured under license
from Dolby Laboratories
Licensing Corporation.
“DOLBY“ and the double-D
symbol a are trademarks of
Dolby Laboratories Licensing
Corporation.
z To locate the beginning of
a tape and start playback
automatically (Auto Play)
Press 0 while holding
down ·. For the reverse
side, press ) while holding
down ª.
z To play a tape recorded
with the Dolby NR*
system
Set DOLBY NR to the same
position that the tape was
recorded in—B or C.
z What is the Dolby NR
system?
The Dolby NR (noise
reduction) system eliminates
tape hiss noise by boosting
low-level signals in the high-
frequency range during
recording, then lowering
them during playback. Type
C provides greater noise
reduction than type B.
z You can connect the
headphones to PHONES
(TC-WE405 only)
With the side you want to play
facing you
PHONES
POWER
DECK A DECK B
COUNTER RESET
PAUSE REC MUTE REC
START(DECK B P)
SYNCHRO DUBBING A
→
B
HIGH/NORMAL
FADER ARL
DIRECTION
Da
RELAY
DOLBY NR
OFF B C
AUTO
PrR
0)
p
ª·
§
0
)
ª·
§
REC LEVEL
5
4
3
2
1
0
6
7
8
9
10
p
24 3
To Next Page
Loading...
