警告
请勿使本装置被雨水淋湿或者受潮，以
防造成火灾或电击。
欢迎使用本产品！
•
•
•
•
N
准备工作
装入电池
１ 打开左边耳机上的电池舱盖（
v
）。
２ 将 Ｒ６ 干电池装入电池舱，装入时请
将电池 3 极与舱内 3 标记对准。
３ 合上电池舱盖。
电池寿命
*
*
关于电池
•
•
•
何时需要更换电池
N
操作方法
收听节目
收听以前
•
•
１ 打开显示器。
２ 将左边耳机上的电源开关设定为 ＯＮ。
３ 戴上耳机。
４ 开始播放。
５ 转动 ＶＯＬ 控制拨盘调节音量。
如果噪音变大，声音会自动降低
— 衰减功能
选择声道
收听节目以后
更换耳机垫
１ 将旧耳机垫拉出取下。
２ 将新耳机垫包在耳机上。
N
其他信息
注意事项
•
•
•
•
˚C
˚C
•
关于使用耳机时防止听力受损
顾及他人
故障诊断
无声音／声音含混不清
,
,
,
•
•
,
•
声音失真
,
•
背景噪音过大
,
,
,
,
,
•
规格
概述
提供的附件
中文
舱盖（
v
）
电源（ＯＮ／ＯＦＦ）开关 ＰＯＷＥＲ（电源）指示灯
耳机垫
ＶＯＬ 控制拨盘
Notes on headphones
preventing hearing damage
Avoid using headphones at high volume.
Hearing experts advise against continuous,
loud and extended play. If you experience
a ringing in your ears, lower the volume or
discontinue use.
Caring for others
Keep the volume at a moderate level. This
will allow you to hear outside sounds and
to be considerate to the people around you.
If you have any questions or problems
concerning the headphones that are not
covered in this manual, please consult your
nearest Sony dealer.
Troubleshooting
No sound/Muffled sound
, Turn on the display monitor first, and then
put on the headphones.
, Check that the display monitor is turned
on.
, The attenuate function is activated.
• Check if there is any object between the
transmitter and the headphones.
• Use the headphones near the
transmitter.
, The headphones’ power indicator light
dims, flashes or goes off.
• Replace the batteries with new ones.
Distorted sound
, The headphones’ power indicator light
dims, flashes or goes off.
• Replace the batteries with new ones.
Loud background noise
, Move closer to the transmitter. (As you
move away from the transmitter, more
noise is likely to be heard. This is inherent
in infrared ray transmission and does not
mean that there is a problem with the
headphones.)
, Check that there are no objects between the
transmitter and the headphones.
, Check that the infrared sensors are not
obstructed by your hands or hair.
, Use the headphones away from direct
sunlight.
, The headphones’ power indicator light
dims, flashes or goes off.
• Replace the batteries with new ones.
Specifications
General
Modulation system
Frequency modulation
Carrier frequency
Right :
2.8 MHz (CH1)/3.8MHz (CH2)
Left :
2.3MHz (CH1)/3.2MHz (CH2)
Frequency response
18 – 22,000 Hz
Power source DC 3.0 V; using R6 dry batteries
(2)
Mass Approx. 230 g including
batteries
Supplied accessory
Operating instructions (1)
Design and specifications are subject to change
without notice.
电池
近似小时数*
１
*
*
To Previous Page
Loading...
