1-30
MVS-8000X/7000X
D1411 (E-1) : SDI3
Indicates the confi guration error of the FPGA.
If this LED lit, the FPGA (IC4) can possibly be working
incorrectly.
D1412 (E-1) : SDI2
Indicates the confi guration error of the FPGA.
If this LED lit, the FPGA (IC3) can possibly be working
incorrectly.
D1413 (E-1) : SDI1
Indicates the confi guration error of the FPGA.
If this LED lit, the FPGA (IC2) can possibly be working
incorrectly.
< Switch >
S501 (K-1) : RST
Reset the MIX board. Pressing this switch initializes the
MIX board.
S901 (L-1) : MON
For monitor switch used in maintaining through the termi-
nal pin.
S902 (M-1) : CPU RESET
This is a reset switch used for design.
< LED on the CPU-DP Module >
Refer to < LED on the CPU-DP module > in “1. CA-82
board”.
< Switch on the CPU-DP Module >
Refer to < Switch on the CPU-DP module > in “1. CA-82
board”.
To Next Page
Loading...
