EasyManua.ls Logo

Sony MVS-6500 System User Manual

Sony MVS-6500 System
57 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
C:\#works\120700485_MVS_SUG\120700485_AEEG100011_GB\4448461111_4448463111\MVS6
500_3000SY\01GB08CV4-SYL.fm
masterpage:Left
MVS-6500 System
4-448-461-11 (1)
MVS-6500 System
(SY)
4-448-461-11 (1)
Sony Corporation
Printed on recycled paper.
Printed in Japan
2012.09 32
© 2012
01GB01COV-SYL.book Page 58 Tuesday, September 18, 2012 7:13 PM
C:\#works\120700485_MVS_SUG\120700485_AEEG100011_GB\4448461111_4448463111\MVS6
500_3000SY\01GB01COV-SYL.fm
masterpage:Right
MVS-6500 System
4-448-461-11 (1)
Multi Format Switcher System
MVS-6500 System
(With ICP-6520/6530 Control Panel)
MVS-6520 MVS-6530 ICP-6520 ICP-6530
ICP-6511 MKS-6550 MKS-6570
Startup Guide [English]
Software Version 1.00 and Later
1st Edition
01GB01COV-SYL.book Page 1 Tuesday, September 18, 2012 7:12 PM
MVS-6500 System
4-448-461-11 (1)

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the Sony MVS-6500 System and is the answer not in the manual?

Sony MVS-6500 System Specifications

General IconGeneral
BrandSony
ModelMVS-6500 System
CategorySwitch
LanguageEnglish

Summary

Overview

Introduction

Describes the purpose and scope of the startup guide.

Names of Parts

Switcher Processor Rear Panels

Describes the rear panel of the MVS-6520/6530 switcher processor, including input/output connectors.

Processor Connectors

Details AC IN, PRIMARY INPUTS, OUTPUTS, and other connectors on the processor.

Control Panel Rear Panel

Describes the rear panel of the ICP-6520/6530 control panel.

ICP-6511 Menu Panel Components

Details the connectors and layout of the ICP-6511 menu panel.

Connection

MVS-6500 System Configuration

Illustrates the overall system setup and signal flow.

Device Control Systems

Shows how external devices connect for control.

Peripheral Device Connection

Diagrams for connecting cameras, VTRs, and generators.

External Monitor Connection

Details on connecting external monitors for preview or operation.

Preparation

Preparation Procedure Overview

Outlines the essential steps for system setup before operation.

Powering On/Off and Menu Navigation

Guides for system power management and menu access.

Network and Signal Format Configuration

Steps for network setup and signal format settings.

Signal Assignment and Output Configuration

Procedures for assigning signals to buttons and configuring outputs.

Multi Viewer Setup and Tally Configuration

Configuring multi viewer and tally outputs.

Setting Tally

Parallel and Serial Tally Configuration

Configures parallel tally outputs and serial tally outputs for program/preview.

Setting Tally Generation References

Configures references for tally signal generation, including enable settings.

Tally Type and Source Assignment

Defines tally types and assigns source addresses for serial tally.

Tally Destination Mapping and Source Lists

Lists available destinations for tally and source assignments across multiple pages.

Assigning 8-Keyer Buttons

Assigning Keys to Control Panel Buttons

Mapping key functions to cross-point control buttons.

Assigning Keys to Transition Buttons

Mapping key functions to next transition selection buttons.

Setting the Startup State

Selecting the Startup Mode at Power On

Configuring the system's behavior upon startup.

Customizing User Default Settings

Saving and recalling custom user configurations.

Saving Data to Removable Disk

Setting Up a Removable Disk for Use

Procedure to register a USB disk as a primary device.

Saving and Recalling User Settings

How to save and load user default settings to/from removable media.

Setting Simple Connection of AUX Bus Remote Panel

AUX Bus Remote Panel Simple Connection

Steps for connecting the MKS-8080/8082 without an S-Bus link.

Exporting Signal Names for Remote Panel

Transferring input/output signal names to the remote panel.

Basic Image Creation Operations

Video Switching and Transition Types

Introduction to video switching and different transition types.

Performing Cut, Wipe, and Mix Transitions

Guides for executing cut, wipe, and mix video transitions.

DME Wipe Settings and Snapshots

Configuration and saving of DME wipe effects and snapshots.

Inserting Titles (Keys)

Understanding Video Keys and Luminance Titles

Explains video keys and how to insert titles using luminance.

Managing Multiple Keys and Display Priority

Guides for inserting additional keys and adjusting their display order.

Composing Images using Chroma Keys

Understanding Chroma Keying

Explains the process of chroma keying for image composition.

Executing Auto Chroma Key

Steps to perform an automatic chroma key operation.

Related product manuals