27
Setting Tally
Preparation
2
Set the tally generation reference.
Tally Enable menu
New menu
a Open the Engineering Setup >Router/Tally >Tally
Enable menu (7364).
b Check the tally settings for the program output.
If the settings of “OUT001” are as follows, you do
not need to change the settings. Proceed to step g.
c Press [New].
The New menu (7364.1) appears.
d Set each of the [Destination Address], [Destination
Level], and [Tally Type] parameters to “1”.
e In the <Tally Enable> group, select [Enable].
f Press [Execute].
g In the Tally Enable menu (7364), check the tally
settings for the preview output.
If the settings of “OUT002” are as follows, you do
not need to change the settings. Proceed to step 3.
h Repeat steps c to f to make settings for the
preview output.
In step d, set the [Destination Address] parameter
to “2”, [Destination Level] parameter to “1”, and
[Tally Type] parameter to “2”.
3
Set the serial tally output.
Serial Tally menu
Source Assign menu
a Open the Engineering Setup >Router/Tally >Serial
Tally menu (7367).
b In the <Serial Tally Port> group, select the target
port.
In this example, select [Panel Port].
Setting Destination Level Tally Type Enable
Value OUT001 1 R1 Enable
New Tally settings for program output
Enable
Destination Address
Destination Level
Execute
Tally Type
Setting Destination Level Tally Type Enable
Value OUT002 1 G1 Enable
Tally Group
Serial Tally Port Source Assign
Tally Type
All Clear Serial Tally Port
To Next Page
Loading...
