Sony MVS-6500 System - Preparation; Preparation Procedure Overview

15
Preparation Procedure
Preparation
Preparation
Preparation Procedure
This section describes the setup required before operation
in the MVS system.
Turn on the power (1 p. 16)
m
System settings
Configure the network (1 p. 19)
m
Set the signal format (1 p. 20)
m
Signal settings
Assign input signals (1 p. 21)
m
Assign output signals (1 p. 23)
m
Other settings
Make the following system configuration and other
settings, as required.
• Configure multi viewer (1 p. 24)
•Set tally (1 p. 26)
• Assign buttons required for 8-keyer operation
(MVS-6530 only) (1 p. 36)
• Set startup mode (1 p. 37)
• Save data to removable disk (1 p. 39)
• Set simple connection of AUX bus remote panel
(1 p. 41)