Sony PHV-A7 - Precautions for Use; General Safety Guidelines; Installation and Environmental Placement; Connection and Operation Tips

ad gsversteiile) ars
On safety
On Installation
On connection
Operate the unit only on 120V AC, 60Hz.
Should any liquid or solid object fall into the cabinet, unplug the
unit and have it checked by qualified personnel before operating
it any further.
One blade of the plug is wider than the other for the purpose of
safety and will fit into the power outlet only one way. If you are
unable to insert the plug fully into the outlet, contact your
dealer.
Unplug the unit from the wall outlet if it will not be used for an
extended period of time. To disconnect the cord, pull it out by
grasping the plug. Never pull the cord itself.
Do not install the unit in a location near heat sources such as
radiators or air ducts, or in a place subject to direct sunlight,
excessive dust, mechanical vibration or shock.
© Before connecting, be sure to turn off all equipment.
Insert plugs securely, as loose connections may cause hum and
noise.
¢ To disconnect the cord, pull it out by the plug. Never pull the
cord itself.
¢ To avoid interference, turn off equipment not in use.
{f noise occurs in the picture or sound, move the pieces of
equipment farther away from each other.
For details on connections, refer to the instruction manual
covering the corresponding equipment.
When the unit will not be used, turn the power off to conserve
energy and to extend the useful life of your unit.
Clean the cabinet and controls with a soft cloth lightly moistened
with a mild detergent solution. Do not use any type of abrasive
pad, scouring powder or solvent such as alcohol or benzine.
To clean the plate which covers the light source part, remove the
film carrier.
Clean the lens and film with a blower. If dust is on the lens, it will
be displayed on the screen.
Do not throw away the carton and the packing material. It makes
an ideal container to transport the unit in.