8GB
To prevent making unnecessary
hole or attaching tape to an
unsuitable site of the car, install
the remote commander and
adaptor to a site where they can
definitely send and receive the
IR signal.
Note
Be careful to do not damage cables
and other items in the car when
making a hole on the car or
tightening the screw.
1 Make a hole with a diameter
of 2 mm on the installation
site of your car.
2 Peel the tape on the bottom
of the holder and attach it
on the installation site.
Fix the hole of the holder on
the hole of the car.
3 Install the supplied screw
to the hole of the holder
and secure it to the
installation site.
4 Set the remote commander
with the lithium battery to the
holder .
Insert the groove of the
remote commander in the
hook of the holder , and
push the remote commander
until it clicks.
To remove the remote
commander
1 Pull the remote commander
while pressing holder release
buttons on both sides of the
holder at the same to
remove from the holder .
To Next Page
Loading...
