HELP
HVR-A1J/A1U/A1N/A1E/A1P/A1C
HELP
Apply grease (1)
Application of grease, soldering method and precautions, and phase
matching adjustment are compiled and below.
D
3
Screw
(M1.2
×
1.5)
4
Motor holder
Motor holder (bottom)
Side of motor worm
Amount of grease application
: Grease of a ball of 1.0 mm
diameter (2 locations)
5
L-motor block assy
(loading) (M9002)
2
Worm shaft (2J)
1
Motor holder base
Washer
Relay gear
Conversion gear
Conversion
gear shaft
Conversion
gear shaft
Apply grease
Apply grease when installing
Amount of grease: A ball of
grease of 1.0 mm diameter
Conversion
gear shaft
Belt
Side of inside
Apply grease when installing
Amount of grease: A ball of
grease of 1.0 mm diameter
Cam bear ass'y
Cam bear ass'y
Do not apply grease to the
locations other than those specified .
Make sure to follow the amount of
grease to be applied.
Screw
(M1.4
×
1.4)
To Next Page