③
When holding board, do not hit/touch to Plastic part(s).
④
After take defective board out from TV, put it into ESD bag.
Do not place on floor mat/carpet direct. And, always put it on
ESD cushion.
※
Installation example of wrist-strap.
Please connect the clip to the metal part of the chassis of the TV with the wristband
grounded. Below is a grounding example of each model.
＜
K*-65Z9F
＞
※
Caution
ESD wrist-strap to be checked daily.
Use Multi-meter to make sure resistance of ESD wrist-strap is OK.(R=750K Ohms to
35Mega Ohms).
8
1-4. Caution About the Lithium Battery.
1) Danger of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type.
2) Outer case broken battery should not contact to water.
SAFETY NOTES
To Next Page
Loading...
