Listening to audio content on your Mac,
iPhone, iPod touch or iPad
4-418-920-11(1)
©2011 Sony Corporation Printed in China
Turning the speaker on
Connect the unit to an AC power source with the AC
adaptor and the AC power cord.
Set the OPERATE ON/OFF switch to ON.
Set the STANDBY MODE switch to NETWORK
STANDBY.
Connecting the speaker
(network settings)
WPS* push button configuration method
Press the WPS button on the access point.
Press the WPS button on the speaker for three
seconds.
Make sure that your Mac/iPhone, iPod touch or iPad are
within the same network as the SA-NS500.
* WPS is a standard for easy and secure establishment of a wireless
home network. Many new wireless LAN routers/access points come
with this feature.
Manual wireless set up
For Mac
1 Connect the unit and the access point using a network
(LAN) cable.
2 Start Safari and Select “Bonjour” under “Bookmark menu”.
3 Select “SA-NS500.”
4 Start wireless setting from Browser.
Tips
For details on the wireless settings, refer to “Option 1: Manual wireless
setup” in the operating instructions.
For details on the connection process and terms, refer to “Option 1:
Manual wireless setup” in the operating instructions.
For details on Safari, refer to the Safari help.
For iPhone, iPod touch or iPad
Check the following customer support site
http://esupport.sony.com/ for customers in the United States
http://esupport.sony.com/CA/ for customers in Canada
Search for further information using the word “SA-NS500.”
You will find “How to stream music to SA-NS500 from iPhone,
iPod touch or iPad” at the above.
You can play audio from an iPhone, iPod touch or iPad, and also from a Mac.
Continued
Control & stream
To Next Page
Need help?
General
