Sony SL-5000 - Service Manual Corrections; Section 1 General - Page 1-1 General Corrections

SERVICE MANUAL
corrected portion ©
, *
1. SECTION 1 GENERAL
Page 1-1. GENERAL
Operate on 120 volt, 60Hz AC. DO NOT ATTEMPT TO
OPERATE YOUR VCR ON HIGHER VOLTAGES, 50 CYCLES
OR DC. The power cord has a polarized plug with one regular
blade and one wide blade. It will fit into the standard electrical
outlet ONLY ONE WAY. If the blades will not enter your
outlet, try reversing the plug. If it will not enter either way, your
outlet is non-standard. A new outlet should be installed by a
qualified electricians DO NOT DEFEAT THE SAFETY
PURPOSE OF THE POLARIZED PLUG.
Keep the recorder and video cassette away from strong magnetic
fields.
After playing a video cassette, remove it from the recorder. DO
NOT move the recorder with a cassette in the compartment.
If a cassette has been subjected to cold temperature, allow it to
warm to room temperature before recording or playback.
To disconnect the cord, pull out by the plug. Never pull on the
cord.
Operate the recorder only on a level, horizontal surface.
DO NOT install the recorder on an inclined surface.
On the top and bottom of this VCR are slots which permit air
flow. DO NOT ENCLOSE THE CABINET OR OTHERWISE
OBSTRUCT VENTILATION AT THE TOP OR BOTTOM.
DO NOT install the recorder in a location near heat sources, or
in a place subject to direct sunlight, dust, mechanical vibration,
shock, or dampness. Moisture may cause damage to tape and
recorder heads.
When you are going away on vacation, or don’t plan to use the
recorder and TV, unplug them from the wall outlet to protect
against possible damage from lightning or power system surges.
If connected to an outdoor antenna, disconnect the lead-in from
the back of the unit.
Should any liquid spill into, or solid object fall onto the cabinet,
unplug the recorder and have it checked by a distributor-
approved Zenith Service Center before attempting to operate it.
To clean the cabinet panels and controls, use a dry or slightly
damp soft cloth. If a damp cloth is used, moisten it with a MILD
detergent. DO NOT use solvents, such as alcohol or benzine
which may damage the finish.
Save the shipping carton and packing material. They will come in
handy if you ever have to ship your recorder. For maximum
protection, re-pack the recorder as it was originally shipped from
the factory.
Beta
Consumer
VIDEO
CORRECTION
Correct the service manual as shown below,
US Medel
Canadian Mode!
No. 1
October,1981
Operate on 120volt, 60Hz AC. DO NOT ATTEMPT TO
OPERATE YOUR VCR ON HIGHER VOLTAGES, 50 CYCLES
OR DC. The power cord has a polarized plug with one regular
blade and one wide blade. It will fit into the standard electrical
outlet ONLY ONE WAY. If the blades will not enter your
outlet, try reversing the plug. If it will not enter either way, your
outlet is non-standard. A new outlet should be installed by a
qualified electrician. DO NOT DEFEAT THE SAFETY
PURPOSE OF THE POLARIZED PLUG. ,
Keep the recorder and video cassette away from strong magnetic
fields.
After playing a video cassette, remove it from the recorder. DO
NOT move the recorder with a cassette in the compartment.
If a cassette has been subjected to cold temperature, allow it to
“warm to room temperature before recording or playback.
To disconnect the cord, pull out by the plug. Never pull on the
cord,
Operate the recorder only on a level, horizontal surface.
DO NOT install the recorder on an inclined surface.
On the top and bottom of this VCR are slots which permit air
flow. DO NOT ENCLOSE THE CABINET OR OTHERWISE
OBSTRUCT VENTILATION AT THE TOP OR BOTTOM.
DO NOT install the recorder in a location near heat sources, or
in a place subject to direct sunlight, dust, mechanical vibration,
shock, or dampness. Moisture may cause damage to tape and
recorder heads.
When you are going away on vacation, or don’t plan to use the
recorder and TV, unplug them from the wall outlet to protect
against possible damage from lightning or power system surges.
If connected to an outdoor antenna, disconnect the lead-in from
the back of the unit.
Should any a into, or solid object fall onto the cabinet,
unplug the er and have it checked by a distributor-
approved SONY Service Center before attempring to operate it.
To clean the cabinet panels and controls, use a dry or slightly
damp soft cloth. If a damp cloth is used, moisten it with a MILD
detergent. DO NOT use solvents, such as alcohol or benzine
which may damage the finish.
Save the shipping carton and packing material. They will come in
handy if you ever have to ship your recorder. For maximum
protection, re-pack the recorder as it was originally shipped from
the factory.
VIDEO CASSETTE RECORDER
SONY.
ae
PIR eS