Sony SPP-Q110 - User Manual

3-856-344-51(1)
Cordless Telephone
Operating Instructions
Manual de instrucciones (reverso)
Setting up the phone
Connect the base unit
If you want to hang the base unit on the wall, mount the unit first (see below).
Positions for screws
Template for mounting the phone on the wall
To determine the positions for the screws, cut out the template below and use it as a
guide. Consider the weight of the phone when you choose the place to hang it.
1
4
Hook
To DC IN 9V
To telephone outlet
To LINE
jack
Telephone line cord
(supplied)
3
To AC outlet
CAUTION
The cordless telephone operates at a frequency that may cause
interference to nearby TVs and VCRs; the base unit should not be placed
near or on the top of a TV or VCR; and, if interference is experienced,
moving the cordless telephone farther away from the TV or VCR will
often reduce or eliminate the interference.
Precautions
• Do not install the phone in a location near a heat source such as radiators or
airducts, or in a place subject to direct sunlight, excessive dust, moisture, rain,
mechanical vibration, or shock.
• If trouble is experienced with this equipment, for repair or warranty
information, please contact your local Sony dealer.
• Do not unnaturally bend or crimp the telephone line cord, and do not place
heavy objects on it.
• Do not connect any other AC power adaptor into the DC IN 9V (external
power input) jack.
• Keep the battery pack away from fire.
• Do not short the battery terminals.
• Do not disassemble the battery pack.
If you have any question or problem concerning your telephone that is
not covered in this manual, please consult the nearest Sony Service
Station authorized to service telephone terminal equipment.
WARNING
To prevent fire or shock hazard, do not expose the unit to rain or
moisture.
To avoid electrical shock, do not open the cabinet. Refer servicing to
qualified personnel only.
Sony Corporation  1997 Printed in Taiwan
SPP-Q110
AC power adaptor
(supplied)
2
1, 2
43
10 cm
5
6
7
Notes
• Use only the supplied AC-T37 AC power adaptor. Do not
use any other AC power adaptor.
• Connect the AC power adaptor to a continuous power
supply.
• Place the base unit close to the AC outlet so that you can
unplug the AC power adaptor easily.
Tip
If your telephone outlet is not modular, contact your telephone service
company for assistance.
Polarity of the plug
Modular
If you mount your phone on the wall
1 Remove the hang-up tab.
2 Reverse the hang-up tab and insert it back.
3 Plug one end of the telephone line cord to the LINE jack and the AC
power adaptor cord to the DC IN 9V jack.
Then attach each cord to the base unit.
4 Attach the screws (supplied) to the wall.
5 Hook the base unit to the screws as illustrated.
6 Using a screw driver, set the voltage selector of the supplied AC
power adaptor to either 110–120 or 220–240V position according to
your local power supply.
7 Plug the other end of the telephone line cord into the telephone
outlet and the AC power adaptor into the AC outlet (using the AC
plug adaptor if necessary). Then fully extend the antenna.
1Connect the telephone line cord to the LINE jack and to a telephone
outlet.
2Using a screw driver, set the voltage selector of the supplied AC
power adaptor to either 110–120 or 220–240V position according to
your local power supply.
3Connect the AC power adaptor to the DC IN 9V jack and to an AC
outlet, using the supplied AC plug adaptor if necessary.
4Fully extend the antenna. Make sure it points toward the ceiling.

Sony SPP-Q110 Specifications