Help Guide
Wireless Speaker
SRS-XB43
How to care for the speaker
Although the fabric part of the speaker has water repellent treatment applied, you can use the speaker more comfortably
and for a longer period of time by following the maintenance procedure below.
When the speaker surface is soiled, immediately wash off the soil with fresh water (tap water, etc.). Leaving the soil
on the surface will cause the fabric part or the passive radiator section to discolor or deteriorate, or cause the
speaker to malfunction.
Ex.
When salt, sand, etc. is stuck on the speaker after using it on a beach, pool side, etc.
When the speaker is stained with foreign substances (sunscreen, suntan oil, etc.)
If the speaker gets wet, wipe off the moisture using a dry soft cloth immediately. In addition, dry the speaker in an airy
place until no moisture remains.
The sound quality may change if water enters the speaker or passive radiator section (
). This, however, does not
indicate a malfunction. Wipe off the moisture on the speaker surface and leave the speaker on a dry soft cloth to let
the water drain out from inside the speaker. Then, leave the speaker in a well-ventilated place to let it dry out.
Note
If the surface of the speaker gets dirty, do not use detergent, thinner, benzine, alcohol, etc. to clean the speaker because it will
affect the water repellent function of the fabric part of the speaker.
Especially in cold regions, be sure to wipe off the moisture after using the speaker. Leaving moisture on its surface may cause
the speaker to freeze and malfunction.
If particles, such as sand grains, enter the fabric or other part of the speaker, remove them with care. Never use a vacuum
cleaner or an equivalent for removal as it may damage the speaker or other unit.
5-011-814-11(1) Copyright 2020 Sony Corporation
To Next Page
Loading...
Need help?
General
Weight and Dimensions
