Using the lists (continued)
To operate the tuner of the receiver
in the main room
To operate the tuner built in the receiver in the
main room in the 3rd room mode, select the
same command mode of the receiver in the
SERVER list.
1 Do steps 1 to 3 in “Setting to the 3rd room
mode”.
2 Move the easy scroll key to select “SET UP”,
then press the key to enter the selection.
The 3-SET UP list appears.
3 Move the easy scroll key to select “SERVER”,
then press the key to enter the selection.
The SERVER list appears.
4 Move the easy scroll key to select “AV
SYSTEMl” or “AV SYSTEM2”. then press the
key to enter the selection.
Clearing all the contents of remote’s
memory
Be sure to turn on the receiver and point
the remote towards the receiver when
performing the following procedure.
1 Press SET UP.
The set up list appears.
2 Move the easy scroll key to select “ALL
CLEAR”, then press the key to enter
the selection.
The ALL CLEAR list appears.
+No
3 Move the easy scroll key to select
“Yes”, then press the key to enter the
selection.
“CLEAR OK?!” appears.
m
4 Move the easy scroll key to select
“Yes” again, then press the key.
All the contents of the remote’s memory (i.e.,
all the programmed data) are cleared.
74
To Next Page
Loading...
