Sony STR-V4L - Page 2

STR-V4L
45 dB (300 kHz) Dynamic Power Output:
70 dB (400 kHz)
Selectivity:
Capture Ratio: 1.0dB Power Bandwidth:
AM Suppression Ratio: 55 dB Damping Factor:
Image Response Ratio: 45 dB Harmonic Distortion:
IF Response Ratio: 95 dB
Spurious
Response
Ratio:
75dB
IM
Distortion:
RF intermodulation: 60 dB (60Hz : 7kHz = 4: 1)
Muting Threshold: Approx. 5 uV Redcyal Noles:
Sub-carrier Product Ratio: 40dB Frequency: Response:
AM (MW/LW) SECTION
Frequency Range: MW: 530—.1,605 kHz
LW: 150 — 350 kHz
Inputs:
IHF constant power supply method
150
W
(8
2)
'
ae
10 — 35,000 Hz, IHF
40 at 1 kHz (8 2)
Less than 0.1 % at rated output
Less than 0.05 % at 1 W output
Less than 0.1 % at rated output
Less than 0.05 % at 1W output
Less than 0.3 mV (—70.6 dB) (A-network) ai:
PHONO:
RIAA equalization curve + 0.8 dB
TAPE1, 2), 7
REC/PB 40.5 dB :
5 — 50,000 Hz _2 dB
Weighting
Impedance
P network
Antenna: Built-in ferrite-rod antenna
External antenna terminal
Intermediate Frequency: 468 kHz Sensitivity
Usable Sensitivity; MW: 200 4V/m (46 dB/m), PHONO
2.5 mV (-50dB) |
50 k2 A
built-in antenna (1,000 kHz)
100 nV (40 dB),
external antenna (1,000 kHz)
LW: 450 uV/m (52.8 dB/m),
built-in antenna (250 kHz)
100 nV (40 dB)
external antenna (250 kHz)
TAPE 1,2
REC/PB
Outputs:
S/N Ratio:
150 mV (—14.5 dB)
50 dB (50 mV/m)
Harmonic Distortion: 0.5 % (50 mV/m, 400 Hz) [Voltage
Selectivity: 35 dB (10 kHz) REC OUT 1, 2 | 150 mV (—14.5 dB)
image Response Ratio:
MW: 40 dB (1,000 kHz)
REC/PB 40 mV (—28 dB)
LW: 75 dB (250 kHz) ;
Headphones:
Speaker:
Tone Controls:
AUDIO AMPLIFIER SECTION
Continuous RMS
Power Output: Less than 0.1 % THD, both channels
driven simultaneously
At 20 — 20,000 Hz
50 W +50 W (8 2)
50 W +50 W (42)
At 1 kHz
53 W +53 W (8 2)
50W +50 W (42)
According to DIN 45500
50 W +50 W (8 2)
Loudness Control:
(att. 30 dB)
High Filter:
MODEL !tDENTIFICATION
Specification Label
AC 220V ~ (AEP mode!)
"ac 240V ~ (UK model)
Bae (290w {AEP model)
S90W (UK model)
FTZ:PRUFNUMMER U185 (AEP model)
50 kQ A
Measured with rated output power into 8 Q loads
(both channels driven simultaneously) at 1 kHz.
(with rated input, FM 30 % modulation, speaker rated output)
[impedance |
Accepts 8 -- 10 2 impedance headphones
4— 16 © speakers are suitable.
BASS: +10 dB at 100 Hz
TREBLE: £10 cB at 10 kHz
+10 dB at 50 Hz
+3 dB at 10 kHz
6 dB/oct. above 6 kHz
OdB = 0.775V