Sony TA-E1000ESD Operating Instructions

WARNING
To prevent fire or shock hazard, do not expose the unit to rain
or moisture.
To avoid electrical shock, do not open the cabinet. Refer
servicing to qualified personnel only.
NOTICE FOR THE CUSTOMERS IN THE UNITED
KINGDOM
IMPORTANT
The wires in this mains lead are coloured in accordance with
the following code:
Blue: Neutral
Brown: Live
As the colours of the wires in the mains lead of this
apparatus may not correspond to the coloured markings
identifying the terminals in your plug, proceed as follows:
The wire which is coloured blue must be connected to the
terminal which is marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the
terminal which is marked with the letter L or coloured red.
Operating Voltage
Before connecting the unit to an AC outlet, be sure that the
operating voltage of your unit is identical with that of your
local power supply.
European countries | Operates on 220 V AC, 50/60 Hz.
United Kingdom Operates on 240 V AC, 50 Hz.
Operates on either 120 V, 220 V
or 240 V AC, 50/60 Hz.
The voltage selector is located on
the rear panel. If the selector
must be reset, disconnect the AC
power cord and turn the selector
with a coin so that the arrow
mark of the selector points to the
proper voltage figure.
Other countries

Sony TA-E1000ESD Specifications

General

Total Harmonic Distortion	0.005%
Signal to Noise Ratio	110dB
Release Year	1990
Input Sensitivity	150mV
Input Impedance	50k ohms
Output	2V (Pre out)
Output Impedance	1 kOhm
Frequency Response	2Hz-200kHz