Sony TA-E1000ESD - Page 29

After programming
Be
sure
to
test
if
the
equipment
really
works
with
the
programmed signals.
If
the
LEARN
indicator
flashes
or
does
not
go
off
in
step
2-@, @
The
memory
capacity
is
full.
This
occurs
when
other
signals
stronger
than
the
remote-control
signals
have
been
stored
because the signals were programmed in a noisy
environment or the remote commanders were placed too far
apart from each other.
— Clear all the signals following the procedure on the right
and program again from the beginning under the proper
conditions.
Notes on programming
e Remote-control signals of equipment of manufacturers
other than Sony can be programmed only when they are
compatible with the infrared wireless remote control
system.
Since
the
programmable
commander
can
“learn”
only the signals output from another remote commander,
it cannot contro! equipment that do not use a remote
commander. Also, note that there are some special
remote-control signals that cannot be programmed.
e Do not attempt to use the programmable system
commander with an air conditionner or other household
appliances.
Programmed b
Follow the programming procedure.
The previously programmed signal is cleared and
replaced by the new signal.
To clear all programmed signals
1 Set the mode selector to LEARN.
2 Press and hold any button of the programmable area
until the LEARN indicator lights up.
3 Press PROGRAM CLEAR until the LEARN indicator
flashes and goes off.
Note.
It is not possible to clear the programmed content of just
one button.
To program a signal onto the @ REC button in the
TAPE or VTR section
It is not possible to operate any equipment with only the
@ REC button. To program a signal on the @ REC
button, press and hold the @ REC button and the button
on the right of the @ REC button at the same time in step
2-0.
Controlling Equipment
By
switching
the
mode
selector
as
shown
below,
a
single
button
alternately
controls
Sony
equipment
and
equipment
of
another
manufacturer.
To control Sony equipment
When Sony equipment cannot be remote-controlled
Program the signal in the same way as for equipment from
other manufacturers. In this case, even with Sony
equipment, set the mode selector to USER STD.
Battery life
Normal operation can be expected for about a half year
using Sony SUM-3 (NS), and a year using Sony AM-3 (NW)
alkaline batteries. If the LEARN indicator does not light
when a button is pressed, the batteries are almost
exhausted. When the batteries are exhausted, the remote
commander can no fonger operate the unit or programming
becomes impossible.
If this happens, replace both batteries with new ones. We
strongly recommend the use of alkaline batteries.
To contro! equipment with
programmed signals
USER STD
aang” “pee
If no signal has been programmed
The programmable commander can control Sony equiprmmt
even when the mode selector is set to USER STD.
If the equipment works incorrectly
Press RESET and operate again. The programmed contats
of the buttons are not cleared by pressing RESET.
29