Sony TA-E1000ESD Operating Instructions

adc siersU1h fe) at
On safety
e Before connecting the unit to the power source, check that
the operating voltage of your unit is the same as the local
power line voltage.
The unit is not disconnected from the AC power source as
long as it is connected to the wall outlet, even if the unit
itself has been turned off.
Should any solid object or liquid fall into the cabinet,
unplug the unit and have it checked by qualified personnel
before operating it any further.
e Unplug the unit from the wall outlet if it is not to be used
for an extended period of time. To disconnect the cord,
pull it out by grasping the plug. Never pull the cord itself.
On operation
Before making program source connections, be sure to
unplug the unit.
Installing the Unit
On cleaning the cabinet
Clean the cabinet, panel and controls with a soft cloth
slightly moistened with mild detergent solution. Do not use
any type of abrasive pad, scouring powder, or solvent such
as alcoho! or benzine.
On side panels (except for the customers in the United
Kingdom)
To detach the side panels, first disconnect the power cord
from the wall outlet. Remove the screws on both sides to
remove the panels and fasten the supplied screws into the
holes on the main unit.
If you have any question or problem concerning your unit,
please consult your nearest Sony dealer.
Tatsielifelicey al
finstallingthe Unit
Place the unit in a location with adequate air circulation to
prevent internal heat built-up in the unit.
This way
Do not install this unit:
- near heat sources such as a radiator or air ducts.
- in a place subject to direct sunlight, excessive dust,
mechanical vibration or shock.
~ in an inclined position.
Do not place anything on the top of the cabinet. The top
ventilation holes must be unobstructed for the proper
operation of the unit and to prolong the life of its
components.
Not this way
Do not throw away the carton and packing material. They
will be an ideal container when the unit is transported.

Sony TA-E1000ESD Specifications

General

Total Harmonic Distortion	0.005%
Signal to Noise Ratio	110dB
Release Year	1990
Input Sensitivity	150mV
Input Impedance	50k ohms
Output	2V (Pre out)
Output Impedance	1 kOhm
Frequency Response	2Hz-200kHz