Sony TA-E2000ESD - Page 51

Specifications
Amplifier section
Frequency response (Parametric EQ, Dynamics, Surround: OFF)
Other than PHONO
Front, Center*, Rear:
10 Hz-20kHz +0.1dB
Subwoofer: Cut off 80Hz, 18dB/oct.
PHONO
VIDEO 1-3 AUDIO OUT, TAPE1, 2
REC OUT: 20Hz-20kHz +0.2dB
Input sensitivity and input impedance
PHONO (MM): 5mvV, 50kohms
TUNER, CD, TAPE1, 2, VIDEO 1-5,
LD, TV: 250mvV, 50kohms
DIGITAL OPTICAL 1, 2: None
DIGITAL COAXIAL: 0.5Vp-p + 20%
75ohms
S/N PHONO
Front, Center, Rear: 84dB (A)
TUNER, CD, TAPE1, 2, VIDEO 1-5,
LD, TV
Front, Center, Rear: 94dB (A)
DIGITAL (OPTICAL 1, 2, COAXIAL)
Front, Center, Rear: 103dB (A)
Remaining noise Below 10 pV (A)
Output voltage and output impedance
VIDEO 1-3 AUDIO OUT, TAPE, 1, 2
REC OUT: 250mV, 470 ohms
FRONT, CENTER, REAR,
SUBWOOFER: 2.5V
DIGITAL OPTICAL 2: None
DIGITAL COAXIAL: 0.5Vp-p +20%,
75 ohms
HEADPHONES: 25mW (at 8 ohms);
accepts low and high impedance
headphones
Total harmonic distortion
Analog input
Front: below 0.004% at 1kHz
Digital input
Front: below 0.003% at 1kHz
“When the PRO LOGIC MODE button is set to WIDE in Dolby
SURROUND Mode.
Video section
Video input sensitivity and input impedance
VIDEO IN
VIDEO 1-5, LD, TV: 1Vp-p, 750ohms
S VIDEO IN
VIDEO1, 2, 5
Luminance (Y): 1Vp-p, 750hms
Chroma (C): 0.286Vp-p, 750hms
Video output voltage and output impedance
VIDEO OUT
VIDEO 1-3, MONITOR1, 2: 1Vp-p,
75ohms
S$ VIDEO OUT
VIDEO 1, 2, MONITOR
Luminance (Y): 1Vp-p, 750hms
Chroma (C): 0.286Vp-p, 750ohms
Digital signal processor section
Parametric equalizer 3-band
center frequency: 18Hz-20kHz, 1/9
oct.-step
Level: + 12dB, 0.1dB-step
Stope (Q): 16-steps
Dynamics Compressor: 1-9, 1-step
Expander: 1-9, 1-step
Surround Main parameter
Room size: 0.5-2.0, 0.1-step
Wall: 0.5-2.0, 0.1-step
Seat position: F50-0-R50, L50-0-R50
1-step
Sub parameter
Early reflection time: 2-500mS**
2mS-step
Early reflection level: 0-100%,
1%-step
Reverb time: 0.3-5.0S 0.1S-step
PRO LOGIC DECODER: ON, OFF
Separation control: 0-10, 1-step
Effect level: 0-100%, 1%-step
Delay time: 15.0-30.0mS,
0.1mS-step
**When Room = 2.0, this is adjustable up to 500mS
A/D, DIA converter section
A/D converter Type: High density linear converter
system
Sampling frequency: 48kHz
Front: Advanced pulse D/A converter
system
Center: Advanced pulse D/A
converter
Rear: Advanced pulse D/A converter
Sampling frequency: 32kHz, 44.1kHz,
DIA converter
48kHz
General
Power requirements AC 120V, 60Hz
Power consumption 38 watts
AC outlets Three switched, total 720 watts
One unswitched, 240 watts
Approx. 470 x 150 x 355 mm
(18% x 6 x 14 inches) (w/hid)
including projecting parts and
controls.
Width when removing the side
panels: 430mm (17 inches)
Approx. 8.5 kg (18 Ib 120z)
Programmable remote commander
RM-P2000 (1)
Sony Batteries SUM-3 (NS) (2)
Audio connecting cord (3)
Screw (4)
Ferrite core (1)
Dimensions
Weight
Supplied accessories
Design and specifications are subject to change without
notice:
A