Sony TA-E2000ESD - Page 55

Symptom
Remote commander does not
operate.
No signal is stored.
Remote Commander
LEARN indicator does not light
even though any button is
pressed.
LEARN indicator goes out after
flashing
Indication is incorrect.
$1 Function of buttons is not
b=}
accepted.
| Operation} [indication
Cause and remedy
The batteries are not inserted correctly.
There is an obstacle between the commander and the amplifier.
The batteries are exhausted.
The mode selector is not set to USER STD despite the fact that you want to
contro! the amplifier with stored signals.
The two remote control units are located near something which might
generate noise, such as a fluorescent lamp.
The batteries of the remote commander supplied or the other manufacturer’s
remote controi unit are exhausted.
The batteries are exhausted.
The internal memory capacity is full.
This is caused by external noise or static electricity.
Disconnect the AC power cord and wait for a while, then connect it again.
This is caused by external noise or static electricity.
Disconnect the AC power cord and wait for a while, then connect it again.