Sony TA-E2000ESD - Troubleshooting Guide

Troubleshooting Guide
Before proceeding through the check list below, examine the connections and
the procedures outlined in the manual. Should any problems persist after you
have checked the following items, consult your nearest Sony dealer.
Video
Symptom Cause and remedy
Power cannot be turned on. The AC power cord is disconnected from a wall outlet.
No sound is heard. The program source equipment is not connected correctly.
No sound or sound at very low The SURROUND function is turned off.
level is heard from rear
The output level of the rear speakers is set to —odB.
speakers.
A monaural program source is being played back in Dolby surround mode.
The PRO LOGIC MODE button is set to 3CH. LOGIC.
The SOURCE DIRECT button is set to ON.
No sound is heard from one The BALANCE contro! is not set properly.
Shane: A speaker cord or connecting cord is disconnected.
Sound is distorted. Output level is higher than the capacity of the speakers.
The indication has appeared.
instrument disposition is obscure The speaker connections are not correct.
or there is lack of bass sound. —The connections should be made with the “+” to *+” and “-" to “*-".
Hum or noise is heard. The earth connection of the turntable is loose.
No picture is seen. The connection is not correct.
The input selection is not correct
Picture is unclear or poor. You have placed the amplifier near a device which might generate noise.