Sony TC-204SD - Timing and Switch Adjustments

_TC-2045D _
PAUSE Timing Adjustment
— Stop Mode —
1.
The
take-up
reel
and
the
pinch
roller
should
stop
at
the
same
time.
If
necessary,
bend
the
spring
as
shown below.
pinch roller (lo 0)
;
Adjust by bending here.
Motor
Switch
(S603)
Position
“Adjustment
—
Stop
Mode
—
1.
Loosen
the
adjustment
screw
and
adjust
the
switch
position
so
that
the
switch
leafs
becomes
6
+0.5mm
(1342)
as
show
below.
_
After
the
adjustment,
secure
the
screw
with
a
suitable
looking
compound.
motor switch (S603)
adjustment
screw
brake release plate
Muting Switch (S602) Position Adjustment
— Stop Mode —
1. Loosen the adjustment screw and adjust the switch
position so that the gap of the switch contacts
becomes 1.0 + 0.5 mm.
1.040.5mm muting switch (S602)
contact
record lock plate
Timing Switch (S601) Position Adjustment
— Stop Mode —
1. Loosen the adjustment screws and adjust the posi-
tion of the timing switch circuit board so that the
muting lever just contacts the switch hole and the
switch starts to move.
2. After the adjustment, secure the screws with a
locking compound.
timing switch
(S607)
adjustment screw
adjustment
screw