Sony TC-WR545 - Page 7

weewgsewes Ge TF ICY RICIGA
sare Walalem stele
Follow the procedure below to play back a cassette on deck A or B.
1 Turn on the amplifier and select the tape
function.
3 Set DOLBY NR to the same position that
was used when the cassette was
recorded.
DOLBY NR
4 Set DIR MODE.
To play back to the
end of one side only
To play back both
sides continuously*
* After playing back five times, the deck
automatically stops.
5 Press <] or > to start playback.
To play back from the front side, press [> .
To play back from the reverse side, press <<] .
The tape direction lights up to show the side you
are listening.
To stop playback, press the IB button.
To stop playback momentarily, press the 11 button
(only on deck B).
To restart play, press the 18 , <J or > button.
To fastwind a tape rightward, press the PP button in
stop mode.
To fastwind a tape leftward, press the 44 button in
stop mode.
Specifying the tape type is unnecessary
The deck has an automatic tape-type detection system.
To begin recording during playback
While holding down the <I or [= button, press the @
button.
The unit immediately begins recording without stopping the
tape. This function is useful when editing previously
recorded material.
When both decks A and B are in playback mode
Only playback from deck A will be audible.
What is the Dolby NR system?
The Dolby NR (noise reduction) system reduces tape hiss
noise in low-level, high-frequency signals by boosting the
signals during recording and lowering them during
playback.
Note
The Dolby HX PRO system works only during recording, not
during playback (TC-WR545 only).