Sony TC-WR545 - Page 9

Locating a Selection — Multi-AMS (Automatic |
WU yremelabiele)
Through its ability to detect the blank space between selections, the Multi-AMS
function allows you to skip up to 30 selections while fast-forwarding or reversing to
the beginning of a specific selection.
During playback, press <4 or >> as many
times as the number of selections to be
skipped.
Playback To locate a
direction selection after
indicator
* Pressing << or PP once locates the beginning of
the current selection.
Tape direction indicator: >=
+ : Beginning of selection
<«[e] <«<[i) [i] >» [ec]
Previous Current Next
selection selection selection
Each time the unit detects a
blank space, the indicated ae aad
Multi-AMS number decreases
by one.
©The PLAY indicator flashes
during Multi-AMS operation.
When the beginning of the
specified selection is reached,
the counter indication appears
again and playback
automatically restarts.
Changing the indicated number of selections to be
skipped
Press the <4 or P> button at any time, even during Multi-
AMS operation.
The Multi-AMS number may change as you are
setting it
due to the detection of blank spaces as the unit begins to
fastwind.
The Multi-AMS may skip a selection in the
following cases:
elf you press the PP (or 44 ) button immediately before
the selection.
elf there is noise in the space before the selection.
elf the space before the selection is less than four seconds
long.
The Multi-AMS will treat the following as blanks:
A long pause in the music
A passage of low frequencies or very low volume
¢A gradual increase or decrease in volume
The Multi-AMS does not function on both decks
simultaneously
The Multi-AMS is disabled on one deck whenever the other
deck is in playback, recording or pause mode.
Note
Even if the DIR MODE switch is set to > , the Multi-AMS
function does not extend to the other side, but stops when
the first side comes to an end.