Sony U-matic S VO-6800PS - Page 14

Operation
The PALISECAM selector on the connector panel of the
recorder is recommended to be set to the appropriate
position according to the program to be recorded so that
the higher picture quality will be assured.
1 Insert a video cassette.
Make sure that the red cap is in place ¢ on the
- pottom of the video cassette.
2 Press the REC button so that the E-to-E mode
signal is displayed’on the monitor screen.
3 Set the input selector of the monitor in accor-
dance with the connectors being used.
VTR: When the 8-pin VTR connector of the
receiver/monitor is used
LINE: When the video line
receiver/monitor is used
input of the
4 Select the TV program and adjust the
receiver/monitor controls for the best possible
picture reception.
5 Adjust the audio recording level.
To record the sound automatically
Set the AUDIO LEVEL MANUAL/AUTO selector |
to AUTO.
To adjust manually
1) Set the AUDIO LEVEL MANUAL/AUTO selec-
tor to MANUAL.
2) For the audio channel 1 adjustment, set the
METER SELECT switch to CH-1.
3) Adjust the audio channel 1 or 2 recording
level by turning the CH 1 or CH 2 LEVEL con-
trol, so that the pointer of the level meter
swings up to 0 dB at its maximum deflection.
6
While
pressing
the
REC
button,
press
the
PLAY
button.
The
recording
will
begin.
To momentarily stop the recording
Press
the
PAUSE
button
on
the
recorder.
The
PAUSE
~
lamp will blink during the pause mode. The E-to-E mode
signal remains displayed on the monitor screen.
To restart the recording, press the PAUSE button again.
eThe pause mode will be automatically released after
about 8 minutes of use, and the recorder will set in the
stop mode in order to protect the tape and the video
heads.
14
AUDIO DUBBING
New sound can be recorded onto a prerecorded tape.
The audio dubbing wil! be made on the audio channel 1
track.
Connections
VIDEO OUT
AUDIO IN
CH-1/L/DUB
For audio recording
Audio source