Using the Wireless Charging Plate
Charging your device
To charge your device using the Wireless Charging Plate
1
Connect the charger to a power supply and plug the charger cable into the
charging port.
2
Place your device on the charging plate. A notification light illuminates for
several seconds after the device is properly placed on the plate. Your device
then starts to charge.
To use the charging plate, some phones must be attached to a Qi certified case that supports
wireless charging. When your device is charging, do not place anything between it and the
charging plate, to avoid interference. Be especially cautious that metal objects don't get in the
way. Such objects can overheat and, if touched, they may cause burn injuries.
The wireless charging receiver of your device is normally located around the battery area,
which may not be at the centre of your device. Be aware of this when placing your device on
the charging plate. Use the notification light on the charging plate or the charging icon on your
device to verify that your device is in the correct position and charging.
Notification light status
Flashes for 2 seconds The charging plate is connected to a power supply
Solid bright light for a few seconds The device is correctly placed on the charging plate
Flashes intermittently The battery is charging
Solid dim light The battery is fully charged
Flashes continuously Charging error
4
This is an Internet version of this publication. © Print only for private use.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
