Sony XT-XM1 - Connection Example; Connection Diagram; Cautions

Connection
Connection example
Cautions
• This unit is designed for negative ground 12 V DC operation only.
• Before making connections, turn the car ignition off to avoid short circuits.
• Connect the yellow power input cord only after all other cords have been connected.
• Run all ground leads to a common ground point.
Connection diagram
XM Antenna*
Sony BUS Compatible
Car Audio*
XT-XM1
CD/MD changer*
* not supplied
POWER
SONY BUS CONTROL
OUT IN L R L R OUT IN
AUDIO
TER SAT
ANTENNA
Yellow
To a +12 V power terminal which
is energized at all times
Be sure to connect the black ground
lead to it first.
Fuse (3 A)
Black
To a metal point on the car
First connect the black ground lead,
then connect the yellow power input
leads.
CD/MD changer
(not supplied)
Sony BUS Compatible
Car Audio
(not supplied)
4
3
XM antenna
(not supplied)
OUT
OUT
IN
IN
Green
Yellow
Connect with the connector
hook facing down.
Connect with a BUS cable to
the XM Satellite receiver,
aligning the v marks.
RCA pin cord
(not supplied)
BUS cable
(not supplied)
2
Note
When you use an optional BUS cable, note
that a BUS cable with an 8-pin plug (L-type)
cannot be used because of its shape.
Note
Locate the power cord and the RCA pin cord as far away as possible.