To Next PageTo Next Page
Need help?Do you have a question about the SORHEA G-FENCE and is the answer not in the manual?
Explains the operational principle of the G-Fence system and its components.
Details the detector cable, its sensors, spacing, and installation on mesh fence.
Describes the Control Unit (UG), its analysis function, and its constituent parts.
Explains the dual function of the Termination/Link Unit (UT/UR) and its installation.
Provides instructions and precautions for installing the Control Unit (UG) on the fence.
Details how to install the detector cable on the fence mesh using tie-wraps.
Instructions for installing the Termination/Link Unit (UT/UR) on the fence mesh.
Detailed wiring instructions for the Control Unit (UG), including auxiliary inputs and MAXIBUS III.
Explains wiring for Termination/Link Units in UT and UR modes, including configuration switches.
Step-by-step guide to enter the configuration mode for the Control Unit (UG).
Describes how to modify parameters in the settings mode using code selection and potentiometers.
Details advanced settings for sensitivity adjustment and filtering, available for specific cable serial numbers.
Instructions on how to exit the settings mode and return to detection mode.
Provides detailed explanations for various parameter codes used in settings.
General| Technology | Microwave |
|---|---|
| Power Supply | 12 - 24 VDC |
| Detection Principle | Doppler effect |
| Alarm Output | Relay NO/NC |
| Material | Aluminum |
