ATTENTION
Depending on the payload, the WorkMo presents a
significant burden. To keep the stress for one’s back as low as possible,
the WorkMo should be rolled using appropriate transport means whenever
possible. Please pay attention to ergonomic lifting when lifting loads!
wrong ✕ correct ✔
Sortimo offers the following extension possibilities in order to roll the WorkMo:
Reference number Name Application
1000003706 Roller WorkMo 24 WorkMo 24-500, WorkMo 24-750
1000003707 Roller WorkMo 34 WorkMo 34-500, WorkMo 34-750
1000003708 Roller WorkMo 44 WorkMo 44-500, WorkMo 44-750
6000002992 Roller adapter WorkMo all WorkMos
801014905 AluCaddy, foldable WorkMo 24-500, WorkMo 24-750
The rollers are connected to the WorkMo using a connecting function and
can be removed at any time. The roller adapters are screwed to the WorkMo
and thus mobilise the WorkMo permanently.
WARNING
An insufficiently secured load can be
catapulted through the vehicle in critical driving situations or in
the event of an accident and may result in life-threatening or even
fatal injuries. The WorkMo has to be regarded as mere payload
when transported in the vehicle!
EN EN
Correspondingly, the load securing obligation according to German road
traffic regulations §22 is to be observed!
(Excerpt: “(1) The load including the equipment for securing loads as well as
loading equipment must be stowed and secured in such a way that it cannot shift,
fall over, roll back and forth, fall down or cause avoidable noise even in the event
of a full brake application or sudden evasive movement. In doing so, the approved
technical regulations must be observed.”)
The connecting of the individual modules via the connecting elements is
not sufficient for the load securing. Every individual module is to be secured
separately in the vehicle!
When two WorkMo are transported stacked on top of each other, for example,
it is not sufficient to secure one WorkMo and couple it with the second one!
Every WorkMo must be secured for itself!
Product and technical specifications
Intended use
The WorkMo consists of a base body and the equipment installed in it. The base
body consists of two plastic side parts and an aluminium body. Handles
2
and
connecting elements
1
are integrated into the plastic side parts.
The WorkMo is used as a transporting, organising and working system that offers
the possibility to stow and transport small parts, tools, etc. by means of various
installations and accessories. In addition, the WorkMo can be upgraded to a
mobile workplace using work tops. The WorkMo is not designed for use outdoors;
the content is protected against atmospheric influences to a limited extent only.
Technical Data
WorkMo 24-500 24-750 34-500 34-750 44-500 44-750
Width 526 mm 526 mm 789 mm 789 mm 1052 mm 1052 mm
Hight 506 mm 743 mm 506 mm 743 mm 506 mm 743 mm
Depth 396 mm
Empty weight 6,4 kg 8,0 kg 8,2 kg 9,75 kg 10,00 kg 11,25 kg
To Next Page
Loading...