EasyManua.ls Logo

Sortimo WorkMo 24-500 - Stacking and Connecting Modules; Assembly and Fastening; Fastening Material

Sortimo WorkMo 24-500
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN EN
WorkMo 24-500 24-750 34-500 34-750 44-500 44-750
Number
screw bosses
24 38 24 38 24 38
Maximum payload 100 kg
Maximum
cover load
100 kg
Stacking / Connecting
Individual WorkMo modules can be stacked on top of each other. A combination
of different widths is possible (e.g. 2 x width 2 on top of 1 x width 4). The safety
information concerning the risk of tipping has to be observed again here.
Modules with the same width can be interconnected on both sides to form a
unit using the connecting elements (
1
). To do so, the elements are folded
upwards and strongly pushed onto the locking latch of the upper WorkMo until
they noticeably lock into place. To release the coupling, the connecting
elements have to be strongly pulled outwards again.
ATTENTION
Never carry connected modules together! The coupling
can become loose or the complete unit can tilt, which can cause serious damages
to persons or property.
Assembly
The WorkMo has screw bosses both at the inside and outside, where equipment
or accessories can be attached to.
Fastening material
Only screw sets (ref.no. 1000003777 & 1000003778) available at Sortimo may
be used for the assembly of equipment and accessories! If other screws are used,
the stability of the screw connection is not given and there is the risk of destroying
the screw bosses!
Reference number Name Application
1000003777
Screw set 4 pc.
6x16 WorkMo accessories
Any accessories except for
worktop side wall
1000003778
Screw set 4 pc.
6x35 WorkMo accessories
Worktop side wall
The screws included in the screw sets have a 3 mm hexagon socket.
The tightening torque of 4 Nm is to be observed. Exceeding this may lead
to the damage of the screw bosses.
Maintenance / Cleaning / Care
The WorkMo does not require any special maintenance. However, for the
purpose of sustaining the function and value the WorkMo should be cleaned
regularly. The use of the following articles is recommended for cleaning:
Reference number Name
6000001052 Cleaning fluid plastic, metal 1l
6000001053 Manual pump spray top for cleaning fluid
6000001083 Special sponge for cleaning fluid
6000001084 Special cloth (grey) for cleaning fluid
Maintenance and service
You may find a contact person close to you at
www.sortimo.de/service-kontakt/ansprechpartner
Spare parts and accessories are available at sortimo-shop.de.
Furthermore, the Sortimo team is ready to offer you help and advise:
Monday through Thursday from 8 am to 6 pm and
Fridays from 8 am to 4 pm
Tel. +49 8291 850-499
Tel. +49 800 7678466 (free of charge)
Fax +49 800 7678499 (free of charge)
direct@sortimo.de
sortimo.com/workmo