Use the [Menu] key to return to the previous menu.
Test Mode
This menu allows you to change the playback test mode from auto to
manual. In Manual Test mode you will have to press the [Select] key each
time a new word is to be spoken. In Auto Test mode, the test will
automatically run through a complete sequence without intervention.
Noise Type
This option returns you to the select a test menu
This allows you to change the type of noise the test is presented in at any
time. Use the [Menu] key in this menu to exit the test completely and
return to the select a test group menu.
Return
Selecting this option will return you to the selected test Setup test screen
(see page 10).
Exit Test
Selecting this option will return you to the initial Select a test group menu.
(see page 7).
Noise Cal Distance
Select this option to change the calibration distance for speaker 2 on the
Parrotplus 2 only. The calibration distance for the noise source can be
changed from 75cm to 100 cm and remains set until you select this menu
option again, or power the unit down.
To Next Page
Loading...