Need help?Do you have a question about the SoundCraft Spirit FX16 and is the answer not in the manual?
General| Brand | SoundCraft |
|---|---|
| Model | Spirit FX16 |
| Category | Music Mixer |
| Language | English |
Details on using XLR mic inputs, phantom power, and handling unbalanced sources.
High impedance input for keyboards, drum machines, etc., using TRS jacks.
Control for setting the input signal level to the mixer, affects noise and distortion.
Activates an 18dB/octave filter to reduce bass frequencies and clean up the mix.
3-band swept equalizer for fine-tuning frequency bands of the audio signal.
Used for separate mixes for foldback, effects, or recording, with pre-fade/post-fade options.
Control for sending channel signal to the built-in Lexicon digital effects processor.
Sets the channel signal's stereo image position in the MIX or SUB busses.
Silences all channel outputs except inserts and pre-fade direct outputs.
Routes channel signal to the SUB L & R busses, affected by PAN control.
Routes channel signal to the MIX L & R busses, affected by PAN control.
Enables PFL (Pre-Fade Listen) and SOLO-IN-PLACE monitoring modes.
Controls the precise balancing of source signals for selected outputs.
Dedicated output for direct connection to external devices like tape machines or effects.
Switch to change Direct Outputs from POST-FADE to PRE-FADE for live recording.
Unbalanced, pre-EQ insert point for adding processing units to the signal path.
Master level controls for AUX outputs and associated AFL switches for monitoring.
Master control for FX sends to the Lexicon processor with AFL monitoring.
Option to use SUB L&R faders as audio subgroups or for alternative outputs.
Controls the final output level for the SUB L & R busses.
Controls the final output level for the MIX L & R busses.
Four balanced returns for effects units or stereo sources, mixed to AUX or MIX/SUB busses.
Return for the internal Lexicon effects processor, routed to AUX or MIX/SUB.
Provides echo, reverb, and acoustic treatments to enhance sound.
Rotary switch to select one of 16 factory-programmed effect combinations.
Adjusts and saves two parameters for each effect program.
Allows remote muting of effects using a foot switch connected to the rear panel.
Checks for mains supply, connections, and fuses if the power indicator is off.
Checks phantom power, mic connection, and cable type.
Checks input gain, source connection, inserts, faders, mute, and monitor select.
Checks Mix Master Fader, Mix inserts, and external device status.
Checks monitor control level and monitor select switch.
Checks headphone impedance and level settings.
Guides on setting Lexicon input level and effects level for optimal sound.
Diagram showing typical connections for live sound reinforcement.
Diagram illustrating common setups for audio recording.
Diagram showing speaker zone setup and system installation.
Diagram illustrating typical mixer setup for a place of worship.
Diagram showing setup for on-location broadcasting applications.
Diagram illustrating mixer connections for video editing workflows.
Diagram showing mixer setup for multimedia and hard disk recording.
Diagram showing mixer configuration for conference PA systems.
Diagrams for connecting balanced and unbalanced audio cables.
Diagrams for insert leads and balanced/unbalanced 'Y' cables.
Diagram for connecting a headphone splitter cable.
Details on noise levels, including E.I.N. and crosstalk.
Describes the frequency response of the mixer inputs/outputs.
Specifies the Total Harmonic Distortion plus Noise levels.
Lists impedance values for various inputs and outputs.
Specifies maximum input and output signal levels.
Provides the weight of the mixer and its power supply.
To Next Page