DAB60 / English Instruction Manual
4
RECALL PRESET STATION
Is the same as in DAB mode.
FM INFORMATION
Press the “I/M” button repeatedly to cycle through the information modes. The information is
displayed on the lower segment of the display.
FM MENU
The device must be in FM mode. Enter the FM menu by press and hold the “I/M” button. Select
with the “ ” or “ ” button one of the following settings and press the “VOLUME / ENTER”:
a) Scan setting:
Select the desired option for automatic station search.
- All stations: Search for all stations that can be received. In this case, station search also
stops for weak stations.
- Strong stations only: Only clear stations are searched.
b) System:
See under “SYSTEM SETTINGS”.
BLUETOOTH
®
If you are using a Bluetooth audio device, make sure the working distance is within 10 meters.
Different environment may have effect on the working distance.
1. Press the “POWER / MODE” button repeatedly to select the Bluetooth
®
mode.
2. Turn on the Bluetooth
®
function on your audio device and choose “DAB60”. After your audio
device is paired successfully, the display show “Bluetooth connected”.
3. Press the “VOLUME / ENTER” knob to start or interrupt the playback.
4. Select with “ ” or “ ” the previous or next track.
This unit contains also a hands-free function. If you have connected a mobile phone by
Bluetooth
®
and you get a call, press the “VOLUME / ENTER” button to activate the function.
To hang up the call, press the “VOLUME / ENTER” button again. Reject the call by press and
hold the “VOLUME / ENTER” button. The music playback will be continued. Note: This
function is only available in BT mode!
MOTION SENSOR (PIR)
While people enter into the effective area and make motions, the unit will play automatically.
Otherwise it will turn off automatically after a defined time since there is no detection signal
occurred (for example, people is out of the detective area or makes no motion). Always pay
attention, that no moving curtains or flowers in detection area, otherwise radio will turn on by
moving of them due any reason (e.g. air circulation).
ACTIVATE OR DEACTIVATE MOTION SENSOR
1. Press and hold the “I/M” button to enter the menu.
2. Select with “ ” or “ ” the point “System” and confirm with the “VOLUME / ENTER” knob.
3. Choose the point “PIR Switch” and press “VOLUME / ENTER” to confirm the selection.
4. To activate the function, set “PIR ON”. To deactivate the function, set “PIR OFF”. Confirm
the selection by pressing the “VOLUME / ENTER” knob.
To Next Page
Loading...
