SCD8100 / English Instruction Manual
4
- DRC off: The dynamic range is not reduced.
- DRC high: The dynamic range is sharply reduced.
- DRC low: The dynamic range is slightly reduced
• Prune:
It may be that you can no longer receive some stations after a station scan or change of
location. With this function you can delete these stations from the reception list. Select
“YES” and confirm with the “ENTER / ” button.
• System:
See under “SYSTEM SETTINGS”.
FM
Extend completely the telescopic antenna. Change the position to improve the reception.
Press repeatedly the “ / SOURCE” button, until “FM” is shown in the display.
There are two options to search for and preset radio stations.
• Automatic scan:
Important! Any preset radio stations will be overridden.
Press and hold the "ENTER / " button for approx. 3 seconds. The system scans the
complete frequency band for radio stations. Any stations found will be preset from lowest to
highest frequency.
• Manual scan for audio stations:
Briefly press the “ ” or “ ” buttons or rotate the “TUNING” knob, until you have found
the radio station which you are looking for. If you keep one of the buttons pressed down, the
device will search to the previous, respectively next radio station.
Preset store
Is the same as in DAB mode.
Preset recall
Is the same as in DAB mode.
FM information
Press repeatedly the “INFO / ” button to show the following FM information:
Radio text, PTY, name, mono or stereo broadcast, time, date.
FM Menu
The device must be in FM mode. To enter the FM menu, press the “MENU” button. Select with
the “ ” or “ ” one of the following settings and press “ENTER / ”. You can press the
“INFO / “ button to go back to previous step or you press the “MENU” button to exit the DAB
menu:
To Next Page
