UR2050 operating instruction of English
1. Start the device
When unit is powered up first time, Automatic update function will start automatically and
“PLEASE WAIT FOR SETTING THANKS “is flashing on LCD, When press any key to terminate
this function.
Note: When unit is powered up first time, Automatic update function will start
automatically in 3~5 minutes. If the signal is received, time display on LCD accordingly
When the automatic system setting had been terminate by user, the date and clock are
defaulted to
01.01.2012 ,0:00.
•
The alarms are defaulted to 0:00,
•
The unit is switched off
•
The unit is standby mode
•
Default back light automatically set to dim from 23:00 to 05:59
2. How to setup device
When Radio Off (Auto-Run Mode), Press <MODE> once go to different mode sequentially
Auto-run Mode with Clock display
1．
Set the Clock
2．
Set the Date
3．Set the SDA
4．
Set update switch
5．
Set dimmer work Mode
6．
Set auto dimmer timer switch
7．Set start time of auto dimmer
8．Set end time of auto dimmer
9．
Set Display mode (12/24 hour)
2.1 Set the clock
2.1.1 Press <Mode> once when the unit stays in clock display mode
2.2.2 The clock goes flashing
2.2.3 Press <UP> to advance the clock by 1 minute
2.2.4 Press <Down> to move the clock back by 1 minute
2.2.5 Press and hold <UP> or <Down> to set the clock in fast mode of 10 minutes per step
2.2.6 Press <Mode> once to go to set the date.
4 Of 10
To Next Page
Loading...
