Need help?Do you have a question about the SoundShaker TA-4800 and is the answer not in the manual?
General| Brand | SoundShaker |
|---|---|
| Model | TA-4800 |
| Category | Amplifier |
| Language | English |
Connect the transmitter power supply and the 3032 Y-Cable to the transmitter's Audio In.
Connect the single end of the 3032 Y-Cable to one split end of the 3031 Y-Cable.
Connect the 3031 Y-Cable ends to your receiver and subwoofer, then power the transmitter.
Connect the transmitter power supply and the 3032 Y-Cable to the transmitter's Audio In.
Connect the single end of the 3032 Y-Cable to your receiver.
Connect your receiver to your subwoofer, then power up the transmitter.
Connect the 3120 Long Cable to the SoundShaker port on the back of the 5012 Amplifier.
Attach the 3120 Long Cable to the 81-3108 Short Cables.
Connect each SoundShaker to an 81-3108 short cable.
No, the order does not matter as the signal runs to all outputs when powered.
Check connections, power supplies, and ensure transmitter, amplifier, receiver, and subwoofer are powered.
Yes, it is compatible with any audio system providing an RCA output.
Ensure an audio signal is being sent out; amplifier won't sync without a running signal.
Set Wireless Switch, play audio, and hold Code Button for 3 seconds to start syncing.
Hold the transmitter's Code Button for 3 seconds until the red light turns solid.
To Next Page