Setting the Bass Output Control
The BX is a powerful bass component. This device is equipped with several
different Bass Output selections. If you should need to change the settings,
please use the chart below for guidance. It is recommended: listen using the
factory setting before changing your Bass Output settings.
Settings Amplifier Input Voltage Minimum Speaker Size
2.5 Volts 3V or Less 8” Subwoofers
5.0 Volts 5V or Less 10” Subwoofers
7.5 Volts 7V or Less 12” Subwoofers
10 Volts OH MY GOSH!!!!!!!! SPL Type Subwoofers
Product Specifications
Maximum Input Level. _______________ _ _ _ _
15V rms
Maximum Output Level ________ ___
13 .5V peak
Frequency Response _____ 10Hz - 100KHz; +/-1dB
Total Harmonic Distortion _______ 0.003%
Signal to Noise Ratio ___________ __ -130dB
Balanced Input Noise Rejection ___________ >60dB
Input Impedance ________________
10K Ohm
Output Impedance _______
150 Ohm
Power Supply ____________
High headroom PWM
Power Draw ________________ 150mA
Fuse Rating __________
1Amp (Included)
To Next Page
Loading...
