Need help?Do you have a question about the SoundTracs Solo Live and is the answer not in the manual?
Explains the four-filter design and its capabilities for tone control.
Explains how to create extra mixes for outboard effects or monitor feeds.
Discusses stereo masters as main outputs and their use for PA/recording.
Pre-Fader Listen switch for monitoring signals in isolation.
Red LED indicating channel overload, activated 5dB before clipping.
100mm travel fader for adjusting signal level to groups, masters, and sends.
Three-pin XLR connector for talkback microphone input.
Feeds stereo jack socket on front panel, monitors masters or two-track return.
Sum of stereo masters, controlled by MONO fader, balanced output.
For 16 or 24 input modules, with mains voltage selector and fuses.
For 32 input modules, 2u high rack unit, with IEC connector and fuses.
Lists requirements for a good earth connection using heavy gauge wire.
Details creating a new mains earth stake and clamp connection.
Describes a dual star-point system for connecting equipment to earth.
Details jumper link settings for aux send sources on the Input Channel PCB.
Details jumper link settings for the MONO output signal source on the Master PCB.
General| Aux Sends | 6 |
|---|---|
| Groups | 4 |
| Type | Analog |
| Metering | LED |
| Buses | 4 |
To Next Page