Need help?Do you have a question about the Source Audio HOTHAND3 and is the answer not in the manual?
General| Brand | Source Audio |
|---|---|
| Model | HOTHAND3 |
| Category | Controller |
| Language | English |
Details on connecting the Hot Hand 3 receiver to Soundblox pedals using the 1/8-inch sensor cable.
Instructions for connecting to external pedals via a 1/4-inch expression cable.
Setup guide for simultaneously connecting both Soundblox and third-party pedals.
Controls the range of the output Hot Hand control signal and allows signal inversion.
Manages the sensitivity of the Hot Hand to movement for smoothing.
Adjust the ring's angle and press the CALIBRATE button to set the control output level.
Explains the X, Y, Z axis signals and their distribution to Expression and Sensor Outputs.
How to scroll through six output modes using the CALIBRATE button and MODE LED.
Designed for up to four simultaneous ring/receiver pairs; explains linking process.
Adjusts the Expression Output for compatibility with various third-party effect units.
Details ring and receiver LED states for charging, linking, and communication.
To Next Page