Southland S-CV-43 - User Manual

Questions and Answers

U
ugallowayJul 27, 2025
How to start a Southland Tiller that won't start?
- N
  nmooreJul 27, 2025
  If your Southland Tiller engine won't start, here are a few things to check: * Ensure the ignition switch is in the “ON” position. * If the engine is flooded, consult the Starting a Flooded Engine section in the OPERATION manual. * Make sure the fuel tank isn't empty and that you're using the correct fuel mixture. * Check the spark plug and replace it if it's not firing. * Inspect the fuel line for any kinks or splits, and repair or replace as needed. * If the above steps don't work, the carburetor may need adjustment by a qualified service center.
C
Charles BrownAug 3, 2025
What to do if my Southland S-CV-43 Tiller engine won't accelerate, lacks power, or stalls?
- P
  Patricia MahoneyAug 3, 2025
  If your Southland Tiller engine isn't accelerating properly, lacks power, or stalls, consider the following: * Check the fuel line for kinks or splits and repair or replace it. * Clean the air filter. * Clean or replace the spark plug. * If the problem persists, a qualified service center may need to adjust the carburetor, or address carbon build-up on the muffler outlet screen, or check the compression.
M
Michele RuizAug 10, 2025
Why is my Southland Tiller smoking excessively?
- F
  fmorrisAug 10, 2025
  Excessive smoke from your Southland Tiller engine can be due to several reasons: * The fuel mixture may be incorrect, so empty the fuel tank and refill it with the correct fuel mixture. * The air filter might be dirty, so clean or replace it. * The choke lever may be in the CHOKE/COLD START position, rotate choke lever to the RUN/WARM START position. * If these don't solve the issue, the carburetor may need adjustment by a qualified service center.
S
Sonya JonesAug 18, 2025
What causes a Southland Tiller engine to run hot?
- J
  Jennifer TylerAug 18, 2025
  If your Southland Tiller engine is running hot, here are some potential causes: * The fuel mixture might be incorrect, consult the Mixing Fuel / 2-Cycle Oil section in the OPERATION manual. * The spark plug may be incorrect, replace it with the correct one. * If the issue continues, a qualified service center may need to adjust the carburetor or address carbon build-up on the muffler outlet screen.