Southwest Windpower Whisper 200 User Manual (English)

Other manuals for Southwest Windpower Whisper 200

Owner's Installation, Operation And Maintenance Manual35 pages

Questions and Answers:

B
briggsmistyAug 1, 2025
Why is my Southwest Windpower Portable Generator propeller not spinning?
- A
  Allen GilbertAug 1, 2025
  The propeller of your Southwest Windpower Portable Generator might be stationary due to several reasons: * Ice in the generator or on the propeller. In this case, wait for warmer weather to thaw the ice. * Debris stuck between the rotor and stator. Try gently turning the propeller by hand and use air or a piece of paper to remove any obstructions. * A loose, broken, or rubbing magnet. Contact the factory or distributor to have the rotor removed and the magnets re-glued. * A bad or worn bearing. Contact the factory or a distributor to replace the bearings.
J
Jennifer GriffinAug 7, 2025
What to do if my Southwest Windpower Portable Generator is making a rattling noise?
- G
  georgestephensAug 7, 2025
  If your Southwest Windpower Portable Generator is making a rattling or clunking noise, here's what you should check: * Inspect the generator for any damage. Ensure the generator is not loose in the tower, the rotor is secure on the shaft, the tail is properly attached, the rubber bumper is in place, and wires aren't slapping inside the mast. Repair any damage, retighten mounting hardware, and use a thread-locking compound. * Worn bearings may also cause rattling. Contact the factory to replace the bearings. * A broken shaft can also cause such noises. Contact the factory to replace the shaft.
K
Kimberly DanielAug 11, 2025
Why is my Southwest Windpower Portable Generator propeller hard to start and noisy?
- E
  erinleeAug 11, 2025
  If your Southwest Windpower Portable Generator's propeller is harder to start, has lower output, and is noisier than usual, consider these potential causes: * Ice on the blade. Wait for warm weather, the propeller will eventually shed the ice. Continue running the generator unless there is substantial vibration. * Dirty blade. Clean the blade with mild detergent. * Split, warped, or damaged blade. Contact the factory or distributor to replace the broken or damaged blade. * One or more blades on backwards. Refer to the blade installation instructions.
K
katherine30Aug 16, 2025
How to fix excessive vibration in my Southwest Windpower Portable Generator?
- B
  Brenda CollinsAug 16, 2025
  Excessive vibration or shaking in your Southwest Windpower Portable Generator can be attributed to: * An unbalanced blade. Contact the factory to replace the blade. * A blade that is not tracking correctly. Contact the factory to replace the mounting plate. * An unbalanced rotor (magnet can). Return it to the factory or distributor. * An unbalanced blade plate. Return it to the factory or distributor.

Southwest Windpower Whisper 200 Specifications

General

Brand	Southwest Windpower
Model	Whisper 200
Category	Inverter
Language	English

Southwest Windpower Whisper 200 Owner's Manual

Table of Contents

Other manuals for Southwest Windpower Whisper 200

Questions and Answers:

Southwest Windpower Whisper 200 Specifications