BATTERY INSTALLATION
You must rst install the baery which is located in
the ont protective styrofoam.
NOTE: When changing the baery, always hold
the baery connecting cap while disconnecting or
aaching the baery. Do not pull on the wires.
Doing this could cause the power supply to become
disconnected from the lock.
is safe uses one 9V alkaline baery. Under normal
use the baery will last about 1 year.
When the baery is low and you press a buon on
the keypad, a red light will come on warning you
that the baery is low.
To test the baery, enter your security code. If the
baery is low the red light will come on
momentarily.
To replace the baery, remove the cover by pressing
the tab and turning the cover as shown in the
illustration. Replace the old baery and screw the
cover back in place.
IMPORTANT:
Your safe is delivered with a Safety
Interlock Screw which must be removed
in order for you to lock your safe.
Failure to do so will compromise the
safety and security of your safe.
First open the safe by turning the handle clockwise
and pulling the door open.
Locate the Safety Interlock Screw on the side of the
door; unscrew with a Phillips screwdriver, remove
and discard the screw.
Your safe can now be closed and locked. Do not
lock your instruction manual and/or keys in the
safe. You will need this manual for the instructions
on locking and unlocking the safe.
Safety Interlock Screw
TAB
40664-1511
2
18
To Next Page
Loading...