Sovol SV02 - Loading Filament; Preheat and Feed Filament

1. Preheat
Method 1
Method 2
2. Feeding Filament
Press and hold the extrusion clip, insert the filiment from the
inlet to the position with red line above the small pneusmatic
connector.
Tip ： How to Replace the Filament ？
1. Preheat the nozzle.
Push and hold extruder arm and feed 5-10mm of filament
by hand, then quickly withdraw the filament.
Using this method helps to avoid pulling liquid filament
through the PTFE tube, potentially causing clogs.
8