What to do if my SP Scientific Chiller unit will not start?
If your SP Scientific Chiller unit won't start, first check the power source to ensure the voltage matches what's specified on the serial tag at the rear of the unit. Also, verify that the main breaker is in the 'on' position.
Why does my SP Scientific Chiller compressor shut off and then turn itself back on?
The compressor of your SP Scientific Chiller might be shutting off and restarting due to several reasons: * **Low voltage:** Check the voltage on the unit while it's running; it should be within 5% of what's listed on the serial tag. * **High ambient temperature:** Compare the room temperature to the Ambient Air Requirement in the Installation and Startup guide, and reduce the temperature if needed. * **Dirty or blocked condenser fins:** Clean the condenser. * **Fan not working:** Check if the fan is drawing air across the condenser. If not, contact SP Scientific Service.
General| Brand | SP Scientific |
|---|---|
| Model | FTS FLEXICOOL IMMERSION COOLERS FC50 |
| Category | Chiller |
| Language | English |
To Next Page
