3.- SPRAYING
3.1 Elect the desired pressure turning the ribbed knob clockwise (high) or
counterclockwise (low), deppending on the work to be performed. Remember that to
apply herbicides, the pressure must be low. For fungicides, insecticides, and foliaters,
higher pressure can be used.
3.2 Hold the spray lance well and begin the spraying operation.
3.3 When working at high pressures, preferably secure the gun lever with the
continuous application safety latch.
4.- EQUIPMENT SHUT-OFF
4.1 Lower the accelerator lever completely, push the shut-off button and the machine
will stop working.
5.-CLEANING
5.1 Empty the residues left in the chemicals tank, using the drain outlet.
5.2 Fill the tank with clean water, run the motor a few minutes, pour out the water until it
is transparent. Then turn the motor off and empty the tank completely using the drain
outlet. This operation will help extend the life of the seals and prevent any obstruction
of the checks.
To Next Page
