14. This charger is intended for use by responsible persons and should not be operated
by children or untrained persons without supervision.
15. Always check battery manufacturer’s specifications on charge rates and voltage prior
to charging.
Technical Features:
• Built-in microchip charging control and monitoring system.
• Zero-volt minimum start – can charge a completely flat battery.
• Optimally designed charging cycle designed for Lead Acid / AGM, Gel, and
Calcium, Starting and Deep cycle batteries.
• Comprehensive eight stage charging cycle including: Desulphation, soft start, bulk,
absorption, analysis, boost, float and maintenance stages.
• Automatic adjustment of charging voltages according to environmental temperature.
• Overcharge protection, protecting the battery from damage due to overcharging.
• Reverse polarity, short circuit, overload and high temperature protection.
• LED display simultaneously showing charging voltage, percentage of battery charge
• Battery Testing function while charging (faulty batteries cause the Full Battery Bar
display to flash).
Technical Specifications:
Gel / Calcium / Lead Acid - AGM
Slowly start the charging process
Maximum Current until pre-set voltage reached
Constant voltage with automatic amperage control
Analyse the battery condition
Higher voltage charge at limited current
Constant Voltage at required Current
Pulse to maintain maximum charge
14.2V Gel / 15.6V Cal / 14.7V LA & AGM
Output Voltage (Absorption)
14.2V Gel / 15.6V Cal / 14.7V LA & AGM
13.3V Gel / 13.7V Cal / 13.7V LA & AGM
Output Voltage (Maintain)
13.3V Gel / 13.7V Cal / 13.7V LA & AGM
Short Circuit, Reverse Polarity, Zero-
volt start & High Temperature
Dimensions Incl. Rubber
feet
To Next Page
Loading...