To Next PageTo Next Page
Need help?Do you have a question about the Space SFL 5518 T and is the answer not in the manual?
General| Brand | Space |
|---|---|
| Model | SFL 5518 T |
| Category | Lifting Systems |
| Language | English |
Lists the safety devices integrated into the lift.
Highlights residual risks and their warnings via pictograms.
Specifies compliance with directives and test coefficients for operational readiness.
Outlines essential site requirements like lighting, ventilation, and noise levels.
Details how to prepare the installation site, including floor strength and dimensions.
Describes recessed area preparation with L-shaped profiles for the SFL 5518 TI model.
Guides on placing footboards and connecting hydraulic system to the control unit.
Details footboard positioning and hydraulic connections for the SFL 5518 TI model.
Provides electrical connection requirements, cable specifications, and safety device checks.
Instructs on routing power cable, connecting to terminals, and setting motor rotation.
Explains pneumatic system setup, including pressure regulator and air filter.
Details connecting control panel, limit switches, and pressure switch cables.
Guides on installing control panel and limit switches for the SFL 5518 TI.
Explains how to synchronize footboards using the automatic alignment valve.
Provides steps for bleeding air from the hydraulic system for proper operation.
Details how to secure the lift to the floor using bolts and shims.
Explains how to activate and adjust safety switches, including pressure switch and limit switches.
Details checks for safety devices like alarms, pressure switches, and microswitches.
Describes checking the audible alarm and its activation microswitch for proper function.
Explains how to test the pressure switch by simulating an obstacle.
Details how to verify the functionality of microswitch FC1 by checking obstacle detection.
Explains the "man-present" system where controls stop upon release.
Guides on assembling the ascent ramps and their supports.
Describes how to adjust the levelling of ascent ramps using a screw.
Instructions for fitting the ramp support and securing it with plugs.
Details how to position and fasten covers and the control unit.
Lists forbidden operations and misuse of the lift to ensure safety.
Advises on using only original accessories for safe operation.
Emphasizes the need for trained and authorized personnel for safe operation.
Lists crucial safety checks for the operator before and during use.
Explains the function of each control and command on the lift.
Outlines steps for safe emergency descent, especially during power loss.
Explains the importance of not tampering with safety devices as per European regulations.
Details the procedure for changing hydraulic oil, including frequency and type.
Provides instructions for cleaning solenoid valves using petrol and compressed air.
Guides on cleaning the capacity regulator valve by accessing the central unit's block.
Specifies periodic greasing of cam contact surfaces for smooth operation.
Lists required information for ordering spare parts, like model and serial number.
Refers to figures for detailed identification of machine parts for ordering.
